[HTML1]
Kel-Tec has suspended production of “the world’s most coveted rimfire.” That’s because the PMR-30’s bullets tend to tumble end-over-end rather than spin. It seems there’s a rifling problem which, obviously enough, affects both accuracy and lethality. Kel-Tec says it will cover the costs of a barrel swap (including postage) for consumers who don’t fancy a gun that sings Boy George songs. One problem: they haven’t finalized the new design yet. And as a result of the changes, the PMR-30 will now “look more like a traditional pistol.” Oh dear. Press release after the jump.
As time has progressed, so has the PMR-30. Since the start of the year the PMR-30 has been shipping in full quantities to all of our distributors on a rotating basis (to make it fair for all distributors). Recently we have been made aware of a potential issue that we feel our customers should definitely be made aware of. We are in the middle of a re-design to our barrel due to key-holing concerns. For those unfamiliar with key-holing, basically it is when the bullet tumbles end over end rather than travelling stable with a solid spiral.
It seems as though the 1:16 twist ratio of our barrels isn’t quite preventing these issues from occurring. We are currently testing new twist ratios for the PMR-30 so that these issues no longer occur (1:9 and 1:12). There has also been a cosmetic change to the barrel: we have removed the fluting on the barrel. The initial fluted design was for weight reduction, however it was time-consuming to produce. We have created a new design that matches the weight and decreases production time significantly. It will look like a more traditional pistol.
IMPORTANT: For customers who DO own a PMR-30 and are experiencing key-holing, you may send your barrel in to be replaced by the newly redesigned versions once they are available. When they are available, a status update will be made so that our customers know that they can go ahead and send their barrel in for replacement. Shipping costs will be reimbursed, of course. Once the new design is tested and implemented, we will post all necessary information for sending back your defective barrel for replacement.
As of today: 5/10/2011, we are halting shipments on the PMR-30 to reduce the number of potential key-holing pistols that go out. We estimate a 2-week period until shipments are resumed. We sincerely apologize to everyone who is affected by this. We hope that our customers understand that we are trying hard to make sure that the best possible product goes out.