Previous Post
Next Post

Charlie Sisks Range, c Nick Leghorn

I was hanging out with Charlie Sisk doing some load development in his private indoor range a few weeks back, and we stumbled across a pretty surprisingly accurate subsonic .243 Winchester load. We were trying to find an acceptably accurate load for one of his friend’s kids to start practicing without much recoil or noise (they have a silencer), and after some trial and error we were getting as good a group as if we’s been shooting supersonic. Here’s the data . . .

Brass: .243 R-P New

Powder: Trail Boss 12.1gr

Primer: Federal 210

Bullet: Nosler 70gr Ballistic Tip

COL: 2.610

Barrel twist: 1:10

As for how well it groups? Check out this 100 yard target:

P1230535r

That’s 10 rounds through the same hole, ignoring the one flier, at 100 yards. We could see daylight through the other side.

Since Charlie was super pumped about this load, I figured it was worth sharing. Good luck, and happy loading!

Previous Post
Next Post

31 COMMENTS

    • Nick,
      Was it a 100 yard target, shot at a 100 yards?
      Never seen a private basement 100 yard range. How would you build it?
      Great post on the load. Always liked .243 cartridges.
      Guy22

        • I had considered doing this with a shipping container for pistol distances. This gives me more “ammunition” with which to convince my wife. That said it will most likely require DHS quantities to do so.

      • 1. You need a big enough culvert to handle the ballistic trajectory of the slowest thing you’ll ever shoot down range.
        2. You need a big enough underground room to set up your bench in, with proper ventilation unless you’re just shooting airguns.
        3. You need a target trolley system to hang your targets from the firing line.
        4. You need a light source at the target end of the tube.

    • Please don’t start the “first” stuff.

      Nick, thanks. I haven’t been able to exercise my .243 yet the way I’d like, but this is definitely going on the bookmark list.

    • They recommend using non-jacketed bullets with their powder but I suspected that it had uses beyond what they recommend.

    • It’s said that Trail Boss is a fast handgun powder designed for low pressure applications and that it can quickly go over pressure with jacketed bullets e.g. if one is working up a full power load. Loading sub sonic in an otherwise high velocity high pressure rifle cartridge (SAAMI 60k psi) probably keeps everything safe.

      Trail Boss is ‘fluffy’ and can measure erratically. These loads must have had consistent weights. How was the powder measured?

  1. Serious question, though: what about the sides. If I sneezed while shooting my Mosin, a stray might punch right through the side 80 yards on and still be doing a thousand-or-so piles per hour, be reasonably intact and even retain spin.

    With corrugated, the likelihood of a gentle bounce back into the end zone is only about one in three.

    What’s nearby, apart from the sand past the end?

    Just wondering…

    • On one side there are neighbors, and there’s a berm that runs the full length of the range on that side. But out the back, and the other side, is nothing but state-owned and drilling company owned land as far as the eye can see.

      • Thanks. Just wondering, y’know.

        An infantry rile can pitch ’em a ways, as can most other high power long guns.

  2. Hey Nick, did you guys happen to chrono these rounds? With a known muzzle velocity (among other things), you should be able to calculate free recoil energy.

  3. “We could see daylight through the other side.”

    Daylight inside a private indoor range? Now I am curious!

    Haha, just messin with ya.

    • I was imagining six, but that presupposes that at least five are sixty footers.

      That’s one Hell of a visual.

  4. I came into this thread expecting to get some reloading info for my new .243 build. What I came away with was the burning desire to start tracking down some used shipping containers.

  5. I’m not very familiar with hunting rifle ammunition, but isn’t a .243 reduced to subsonic less powerful than a .38 special

  6. Gday, I tried AS-50 (Australian Shotgun) a ADI powder made in Australia (ADI make Varget), in my .243, using 10.5 grains behind a 75 TNT Speer and got a 75 moa 5 shot group, Speed,, ?? don’t know. Norm, Queensland, Australia.

  7. Hi. I tried the 12.1grains with 70 grain round and is most defiantly not subsonic IMR list 100 grain only needs 8 of powder. I have settled on 8.7 grains with a short nose 100 grain bullet. Its stable in my Howa 1500 with 1:10 twist. It is a nice round and produces very similar results. It is perfect for foxing in and around livestock.

    70 grain bullet i stopped at 7 grains and it was still supersonic. Wouldn’t recommend going any lower on powder.

  8. I have used TB a3 sporter,19gn. Shoots 3/4 ,mow @100. My. 243win w/9.25 twist using 12gns and get 1/2moa @ 100? Both loads I use only standard primers.

LEAVE A REPLY

Please enter your comment!
Please enter your name here